
Because people’s lives can be at stake, OEM takes projects for Medical and Bio-Medical applications very seriously. While somewhat different than mil spec standards, medical requirements must meet the same rigid standards of toughness and long-term failure-proof reliability. OEM understands this and makes sure our operators and technicians are expertly trained and certified so that we can build medical products rated to J-STD-001 Class III standards.
OEM is registered with the FDA and capable of handling many types of medical device projects.
Reliability of PCB Products
On an as-needed basis, OEM can perform burn-in and vacuum chamber tests on medical electronic and PCB products. OEM will help customers pass tests that include:
OEM also employs careful planning at the prototype stage to insure reliability by defining and creating Design for Manufacturability (DFM) and Design for Testability (DFT) procedures at critical stages in product development. We also test using different environmental cycles that check a variety of factors such as voltage cycles, current, temperature and humidity. We use failure rate analysis to improve reliability and create higher yield.
Copyright © 1999-2022 OEM, Inc. All rights reserved. | ![]()
|